REPLACEMENT
PROCEDURE
1. REPLACE STRAIGHT PIN
NOTICE:
It is not necessary to remove the straight pin unless it is being replaced.
(a) Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
Text in Illustration
*A |
Front Side |
*B |
Rear Side |
*C |
Upper Side |
*D |
Lower Side |
Standard Protrusion:
Item |
Specified Condition |
---|---|
Pin A |
22.5 to 23.5 mm (0.886 to 0.925 in.) |
Pin B |
10.5 to 11.5 mm (0.413 to 0.453 in.) |
Pin C |
8.5 to 9.5 mm (0.335 to 0.374 in.) |
Pin D |
5.5 to 6.5 mm (0.217 to 0.256 in.) |
2. REPLACE STUD BOLT
NOTICE:
If a stud bolt is deformed or its threads are damaged, replace it.
(a) Using an E8 "TORX" socket wrench, install the stud bolts. Text in Illustration
Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} |
|
High Power Supply Voltage Malfunction (C1417)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS
operation.
This DTC is stored when the +BS terminal voltage deviates from the DTC detection
condition due to a malfunc ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK BATTERY CONDITION
NOTICE:
If the battery is weak or if the engine is difficult to start, recharge the battery
and perform inspections again before returning the vehicle to the customer.
(a) Check the battery for damage or deformation. If severe damage, ...
System Description
SYSTEM DESCRIPTION
1. FRONT PASSENGER OCCUPANT CLASSIFICATION SYSTEM
(a) General Description
(1) The front passenger occupant detection ECU determines whether the front passenger
seat is occupied by an adult or child (with child seat) or is unoccupied, based
on the load that is applied to the ...