Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE HEATED OXYGEN SENSOR

3. REMOVE HEATED OXYGEN SENSOR

Click here 4. REMOVE TAIL EXHAUST PIPE ASSEMBLY

4. REMOVE TAIL EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts to separate the tail exhaust pipe assembly.

(b) Disconnect the 4 exhaust pipe supports to remove the tail exhaust pipe assembly.

5. REMOVE CENTER EXHAUST PIPE ASSEMBLY

(a) Remove the 2 bolts and 2 compression springs.

(b) Remove the 2 bolts to separate the center exhaust pipe assembly.

(c) Disconnect the exhaust pipe support to remove the center exhaust pipe assembly.

6. REMOVE CENTER NO. 2 FLOOR HEAT INSULATOR SUB-ASSEMBLY (for 4WD)

(a) Remove the 3 nuts and center No. 2 floor heat insulator sub-assembly.

7. REMOVE EXHAUST PIPE STOPPER BRACKET (for 4WD)

(a) Remove the 2 bolts and exhaust pipe stopper bracket.

8. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY

(a) Remove the 2 nuts to separate the front No. 2 exhaust pipe assembly from the exhaust manifold LH.

(b) Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly.

9. REMOVE FRONT EXHAUST PIPE ASSEMBLY

(a) Remove the 2 nuts and front exhaust pipe assembly.

10. REMOVE MONOLITHIC CONVERTER PROTECTOR

(a) Remove the bolt and clamp.

(b) Remove the 2 bolts, 2 nuts and upper monolithic converter protector and lower monolithic converter protector.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Installation
INSTALLATION PROCEDURE 1. REMOVE MONOLITHIC CONVERTER PROTECTOR (a) Install the upper monolithic converter protector and lower monolithic converter protector with the 2 bolts and 2 nuts. Torque: ...

Other materials:

Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that the mute is off. (b) Check that the sound of the portable player can be heard from the speakers. OK: Sound ...

Installing child restraints
Follow the child restraint system manufacturer’s instructions. Firmly secure child restraints to the seats using the LATCH anchors or a seat belt. Attach the top tether strap when installing a child restraint. The lap/shoulder belt can be used if your child restraint system is not compatible ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVER SIDE JUNCTION BLOCK (a) Disconnect the main body ECU (multiplex network body ECU) connectors. Text in Illustration *1 Main Body ECU (Multiplex Network Body ECU) - - ...

© 2011-2024 Copyright www.ttguide.net