Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

3. DRAIN ENGINE COOLANT

4. REMOVE V-BANK COVER SUB-ASSEMBLY

4. REMOVE V-BANK COVER SUB-ASSEMBLY

5. REMOVE RADIATOR SUPPORT TO FRAME SEAL 5. REMOVE RADIATOR SUPPORT TO FRAME SEAL

5. REMOVE RADIATOR SUPPORT TO FRAME SEAL

(a) Remove the 7 clips and radiator support to frame seal.

6. DISCONNECT NO. 2 RADIATOR HOSE

(a) Slide the hose clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.

7. DISCONNECT NO. 7 WATER BY-PASS HOSE (w/ Oil Cooler)

(a) Slide the hose clip and disconnect the No. 7 water by-pass hose from the water inlet with thermostat sub-assembly.

8. DISCONNECT NO. 4 WATER BY-PASS HOSE

(a) Slide the hose clip and disconnect the No. 4 water by-pass hose from the water inlet with thermostat sub-assembly.

9. DISCONNECT NO. 3 WATER BY-PASS HOSE

(a) Slide the hose clip and disconnect the No. 3 water by-pass hose from the water inlet with thermostat sub-assembly.

10. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

HINT:

If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.

(a) Disconnect the connector from the water inlet with thermostat sub-assembly.

(b) Disengage the clamp to separate the wire harness.

(c) Remove the 2 bolts, nut and water inlet with thermostat sub-assembly from the timing chain cover assembly.

(d) Remove the gasket from the water inlet with thermostat sub-assembly.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

Inspection
INSPECTION PROCEDURE 1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY HINT: The valve opening temperature is inscribed on the water inlet with thermostat sub-assembly. (a) Immerse the ther ...

Other materials:

Cargo Light
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY for Double Cab: (See page ) for Access Cab: (See page ) 2. REMOVE CARGO LIGHT ASSEMBLY (CENTER STOP LIGHT ASSEMBLY) (a) Remove the 2 nuts. ...

Installation
INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1) (a) Apply engine oil to a new O-ring and install it to the camshaft timing oil control solenoid assembly in the locations shown in the illustration. Text in Illustration ...

Clearance Warning ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the clearance warning ECU assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuse for circuits related to this system before performing the following inspection procedure. PROCEDURE 1. CHECK HARNES ...

В© 2011-2024 Copyright www.ttguide.net