Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

4. REMOVE BATTERY CLAMP SUB-ASSEMBLY

(a) Loosen the nut and remove the battery clamp sub-assembly.

5. REMOVE BATTERY

6. REMOVE BATTERY TRAY

7. REMOVE V-BANK COVER

Click here 8. REMOVE FAN AND GENERATOR V BELT

8. REMOVE FAN AND GENERATOR V BELT

Click here 9. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

9. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY

(a) Remove the bolt and No. 2 idler pulley sub-assembly.

10. REMOVE NO. 1 SURGE TANK STAY

Click here 11. REMOVE GENERATOR ASSEMBLY

11. REMOVE GENERATOR ASSEMBLY

(a) Disengage the clamp and disconnect the engine wire from the wire harness clamp bracket.

(b) Remove the bolt and wire harness clamp bracket.

(c) Disconnect the connector from the generator assembly.

(d) Remove the terminal cap.

(e) Remove the nut and disconnect the engine wire from the terminal B.

(f) Remove the 2 bolts and disconnect the engine wire from the generator assembly.

(g) Disengage the clamp and disconnect the engine wire from the wire harness clamp bracket

(h) Remove the bolt and disconnect the generator bracket from the cylinder block sub-assembly.

(i) Remove the 2 bolts and generator assembly.

(j) Remove the bolt and generator bracket from the generator assembly.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE GENERATOR PULLEY (a) Mount the generator assembly in the vise between aluminum plates. NOTICE: Do not overtighten the vise. (b) Install SST 1-A to the generator p ...

Other materials:

System Description
SYSTEM DESCRIPTION 1. LIN COMMUNICATION SYSTEM DESCRIPTION The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed through LIN communication because of an open in the communication lines or other reasons, the maste ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION The ECU stores trouble codes when malfunctions occur. The diagnostic system allows for reading of the trouble codes from the DLC3. Use the Techstream to help diagnose and repair the problem. 2. CHECK DLC3 (a) Check the DLC3 (See page ). 3. INSPECT BATTERY VOLT ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MILLIMETER WAVE RADAR WIRE (w/ Toyota Safety Sense P) Click here 2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Toyota Safety Sense P) Click here 3. REMOVE NO. 1 RADIATOR GRILLE GARNISH (a) When Replacing the No. 1 Radiator Grille Garnish: (1) Apply p ...

В© 2011-2024 Copyright www.ttguide.net