Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.

PROCEDURE

1. REMOVE REAR BUMPER ASSEMBLY (w/ Towing Package)

(See page 2. REMOVE REAR BUMPER ASSEMBLY (w/o Towing Package) 2. REMOVE REAR BUMPER ASSEMBLY (w/o Towing Package) )

2. REMOVE REAR BUMPER ASSEMBLY (w/o Towing Package)

(See page 3. REMOVE CONNECTOR COVER (w/ Towing Package) 3. REMOVE CONNECTOR COVER (w/ Towing Package) )

3. REMOVE CONNECTOR COVER (w/ Towing Package)

(See page 4. REMOVE REAR BUMPER HOLE COVER (w/o Towing Package) )

4. REMOVE REAR BUMPER HOLE COVER (w/o Towing Package)

(See page 5. REMOVE REAR BUMPER PAD SUB-ASSEMBLY (w/ Towing Package) )

5. REMOVE REAR BUMPER PAD SUB-ASSEMBLY (w/ Towing Package)

(See page 6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY (w/o Towing Package) )

6. REMOVE REAR BUMPER PAD SUB-ASSEMBLY (w/o Towing Package)

(See page 7. REMOVE REAR BUMPER EXTENSION LH (w/ Towing Package) )

7. REMOVE REAR BUMPER EXTENSION LH (w/ Towing Package)

(See page 8. REMOVE REAR BUMPER EXTENSION LH (w/o Towing Package) )

8. REMOVE REAR BUMPER EXTENSION LH (w/o Towing Package)

(See page 9. REMOVE REAR BUMPER EXTENSION RH (w/ Towing Package) )

9. REMOVE REAR BUMPER EXTENSION RH (w/ Towing Package)

HINT:

Use the same procedure as for the LH side.

10. REMOVE REAR BUMPER EXTENSION RH (w/o Towing Package)

HINT:

Use the same procedure as for the LH side.

11. REMOVE BLIND SPOT MONITOR SENSOR LH

(a) Disconnect the connector.

(b) Remove the 3 nuts and blind spot monitor sensor LH.

12. REMOVE BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure as for the LH side.

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ...

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact. PROCEDURE 1. INSTALL BLIND SPOT MONITOR SENSOR LH (a) ...

Other materials:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the C27 and C29 certification ECU (smart key ECU assembly) connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side w ...

System Voltage Circuit Short to Ground or Open (P056014)
DESCRIPTION The battery supplies power to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the ECM data is cleared and the ECM determines that ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock co ...

В© 2011-2024 Copyright www.ttguide.net