Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

  • Be sure to read Precaution thoroughly before servicing (See page If the side airbag was deployed, replace the front seat airbag assembly ).
  • If the side airbag was deployed, replace the front seat airbag assembly LH, front seatback cover and front seat frame with adjuster assembly with the necessary parts in accordance with the extent of the collision damage.
  • Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure described below is for the LH side.

PROCEDURE

1. REMOVE SEATBACK COVER WITH PAD

(See page 2. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH )

2. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

(a) Disengage the clamp.

(b) Remove the 2 nuts and front seat airbag assembly LH.

CAUTION:

  • The nuts must not be reused.
  • Make sure that the front seatback main frame sub-assembly is not deformed. If it is, replace it with a new one.
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FRONT SEAT AIRBAG ASSEMBLY LH (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre ...

Other materials:

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART LANE DEPARTURE ALERT SYSTEM DTC No. Detection Item Link C1A47 Steering Angle Sensor C1AA0 Front Camera Module Circuit C1AA1 F ...

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) This system uses ultrasonic sensors to detect any obstacles at the corners and the rear of the vehicle. The system then informs the driver of the distance between the sensors and an obstacle as well as their positions by indicating them on the multi-informat ...

Using the radio
Select “AM” or “FM” on the “Select Audio Source” screen to begin listening to the radio. Audio control screen   “Select Audio Source” screen appears   Preset stations   Select to display RBDS text message   Scanning for receivable station   Sele ...

© 2011-2024 Copyright www.ttguide.net