REMOVAL
PROCEDURE
1. REMOVE REAR SEATBACK HINGE COVER
2. REMOVE REAR SEATBACK ASSEMBLY
3. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY
4. REMOVE REAR DOOR SCUFF PLATE
5. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
(a) Disconnect the rear door opening trim weatherstrip to the extent which allows the removal of the quarter trim lower panel and quarter inside trim board. |
|
6. REMOVE LUGGAGE COMPARTMENT SIDE TRAY
7. REMOVE QUARTER TRIM LOWER PANEL
8. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
9. REMOVE QUARTER INSIDE TRIM BOARD
10. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
(a) Loosen the bolt to disconnect the shoulder anchor. |
|
(b) Remove the 2 bolts. |
|
(c) Disengage the 2 guides to remove the rear seat 3 point type outer belt assembly.
Initialization
INITIALIZATION
1. RESET MEMORY
NOTICE:
Perform Reset Memory (AT initialization) when replacing the automatic
transmission assembly, transmission valve body assembly or any of the shift
solenoid valves.
Reset Memory can be performed only with the Techstream.
HINT:
The E ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INDICATOR LIGHT
(a) Inspect the 4HI Indicator Light:
(1) Start the engine.
(2) Change the 4WD control switch from 2WD to 4H.
(3) Check the 4HI indicator light.
OK:
The 4HI indicator light comes on or the 4HI indicator light comes on after it
is b ...
Front Fog Light Circuit
DESCRIPTION
The main body ECU (multiplex network body ECU) controls the front fog lights.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following inspection procedure.
If the main body ECU (multiplex ...