Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for both the RH and LH sides.
  • The procedure described below is for the LH side.

PROCEDURE

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE ACCESS PANEL REAR WEATHERSTRIP

3. REMOVE ACCESS PANEL REAR WEATHERSTRIP

Click here 4. REMOVE LAP BELT OUTER ANCHOR COVER

4. REMOVE LAP BELT OUTER ANCHOR COVER

Click here 5. REMOVE ACCESS PANEL INSIDE HANDLE BEZEL

5. REMOVE ACCESS PANEL INSIDE HANDLE BEZEL

Click here 6. REMOVE DOOR PULL HANDLE

6. REMOVE DOOR PULL HANDLE

Click here 7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Click here 8. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY

8. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY

Click here 9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

(a) Remove the nut to disconnect the shoulder anchor.

(b) Using a screwdriver with its tip wrapped in protective tape, release the locking button to disconnect the connector.

Text in Illustration

*a

Protective Tape

(c) Remove the 2 bolts.

(d) Disengage the 2 guides to remove the front seat outer belt assembly.

10. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

(a) Remove the bolt.

(b) Disengage the guide to remove the front shoulder belt anchor adjuster assembly as shown in the illustration.

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FRONT SHOU ...

Front Seat Outer Belt Assembly(for Double Cab)
...

Other materials:

Automatic High Beam Camera (B124C)
DESCRIPTION The main body ECU (multiplex network body ECU) detects a high beam headlight illumination request signal of the automatic high beam system from the forward recognition camera DTC No. Detection Item DTC Detection Condition Trouble Area ...

Precaution
PRECAUTION 1. EXPRESSIONS OF IGNITION SWITCH HINT: The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

В© 2011-2024 Copyright www.ttguide.net