REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE NO. 1 FRONT WHEEL OPENING EXTENSION PAD (w/ Front Spoiler)
2. SEPARATE FRONT FENDER LINER
(a) Remove the 2 screws to separate the front fender liner. |
|
3. REMOVE FOG LIGHT ASSEMBLY
(a) Disconnect the connector. |
|
(b) Remove the screw.
(c) Disengage the 2 guides to remove the fog light assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL VANE PUMP
(a) Install the vane pump assembly with the 2 bolts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(b) Connect the oil pressure switch connector.
NOTICE:
Make sure that no oil adheres to the connector.
...
Fail-safe Chart
FAIL-SAFE CHART
HINT:
If any of the following auto cancel conditions are detected while the dynamic
radar cruise control system is controlling vehicle speed, the system clears the
stored vehicle speed and cancels control of vehicle speed by the dynamic radar cruise
control system.
Automatic ...
Antenna Coil Open / Short (B2784)
DESCRIPTION
When an open or short circuit is detected in the transponder key amplifier coil
built into the engine switch, the certification ECU (smart key ECU assembly) stores
this DTC. This DTC is also stored as a past DTC.
DTC Code
DTC Detection Condition
Tro ...