REMOVAL
CAUTION / NOTICE / HINT
HINT:
Item |
Temperature |
---|---|
Vehicle Body |
40 to 60°C (104 to 140°F) |
Moulding |
20 to 30°C (68 to 86°F) |
NOTICE:
Do not heat the vehicle body, moulding and clip excessively.
PROCEDURE
1. REMOVE ROOF DRIP SIDE REAR FINISH MOULDING
(a) Put protective tape around the roof drip side rear finish moulding. Text in Illustration
|
|
(b) Using a heat light, heat the roof drip side rear finish moulding.
NOTICE:
Do not heat the moulding and vehicle body excessively.
(c) Using a moulding remover D, disengage the clip, and peel off the double-sided tape to remove the roof drip side rear finish moulding.
NOTICE:
2. REMOVE ROOF DRIP SIDE FINISH MOULDING
(a) Put protective tape around the roof drip side finish moulding. Text in Illustration
|
|
(b) for Double Cab:
(1) Using a heat light, heat the roof drip side finish moulding.
NOTICE:
Do not heat the moulding and vehicle body excessively.
(c) Using a moulding remover D, disengage the clip, and peel off the double-sided tape to remove the roof drip side finish moulding.
NOTICE:
(d) Remove the protective tape.
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals ...
Engine compartment
2.7 L 4-cylinder (2TR-FE) engine
1. Washer fluid tank
2.Radiator cap
3.Engine coolant reservoir
4. Engine oil filler cap
5. Power steering fluid reservoir
6. Engine oil level dipstick
7. Brake fluid reservoir
8. Fuse box
9. Battery
10. Condenser
11. Radiator
4.0 L V6 (1GR-FE) engine
...
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab)
Click here
2. REMOVE FRONT DOOR SCUFF PLATE LH (for Access Cab)
Click here
3. REMOVE COWL SIDE TRIM BOARD LH
Click here
4. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
Click here
5. REMOVE INSTRUME ...