Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / Tire And Wheel / Tire Pressure Warning Valve And Transmitter / Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT WHEEL

2. REMOVE REAR WHEEL

3. REMOVE TIRE PRESSURE WARNING VALVE AND TRANSMITTER

(a) Remove the cap and valve core to release the air from the tire.

NOTICE:

Keep the removed cap and valve core.

(b) After ensuring that a sufficient amount of air has been released, remove the nut and washer used to secure the tire pressure warning valve and transmitter. Drop the tire pressure warning valve and transmitter with the grommet into the tire.

HINT:

The grommet may remain attached to the rim.

(c) After dropping the tire pressure warning valve and transmitter into the tire, disengage the bead using the shoe of a tire remover.

Text in Illustration

*1	Tire
*2	Shoe

NOTICE:

Be careful not to damage the tire pressure warning valve and transmitter due to interference between the valve and the tire bead.
Set the tire remover shoe as shown in the illustration.
Width (A):

10 to 20 mm (0.394 to 0.787 in.)

NOTICE:

Be careful as the tire pressure warning valve and transmitter may become damaged due to interference between the sensor and tire bead.

(d) Separate the upper bead.

(e) Take out the tire pressure warning valve and transmitter with the grommet from the tire and separate the lower bead.

(f) Remove the grommet from the tire pressure warning valve and transmitter.

Installation

INSTALLATION CAUTION / NOTICE / HINT NOTICE: Always use a new grommet and valve core when installing the tire pressure warning valve and transmitter. Check that the washer and nut a ...

Vf2cm Transfer

...

Other materials:

Acceleration Sensor Internal Circuit (C1419,C1435)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. If t ...

Power Source Circuit
DESCRIPTION This circuit provides power to operate the forward recognition camera. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. PROCEDURE 1. CHECK HARNESS A ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Audio and Visual System DTC Code Detection Item See page B1324 Lost Communication with Meter B1532 LVDS Signal Malfunction (from Extension Module) ...