REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. INSPECT FRONT SUSPENSION LOWER ARM
(a) Install the hub nuts onto the disc.
(b) Using a dial indicator, check the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf).
Maximum:
0.5 mm (0.020 in.)
HINT:
If it is not within the specification, replace the lower arm.
3. SEPARATE FRONT SHOCK ABSORBER WITH COIL SPRING
(a) Remove the bolt, nut and washer.
(b) Separate the front shock absorber with coil spring from the suspension lower arm.
4. REMOVE FRONT SUSPENSION LOWER ARM
(a) Remove the 2 bolts, and separate the front lower ball joint attachment from the front axle.
(b) Place matchmarks on the camber adjust cam No. 2 and toe adjust cam. |
|
(c) Remove the nut, camber adjust cam No. 2, camber adjust cam No. 1, bolt, toe adjust cam, toe adjust plate No. 2 and front suspension lower arm.
(d) Remove the cotter pin and the nut. |
|
(e) Using SST, remove the front lower ball joint attachment LH.
SST: 09628-00011
Four Wheel Drive (4WD) Range Signal Circuit Range / Performance (P279E)
DESCRIPTION
When the transfer position switch is switched, the 2-4 terminal and LO terminal
change to one of the following ON/OFF combinations listed in the table below.
Terminal
2WD
Between 2WD and H4
H4
Between H4 and L4
L4
...
SRS Warning Light does not Come ON
DESCRIPTION
See page .
WIRING DIAGRAM
See page .
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following inspection procedure.
After turning the ignition switch off, waiting time may be required
before disconne ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...