REMOVAL
PROCEDURE
1. REMOVE FRONT WHEEL
2. DRAIN DIFFERENTIAL OIL
3. SEPARATE FRONT SPEED SENSOR
(a) Remove the bolt and separate the front speed sensor.
(b) Disengage the 2 clamps.
(c) Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
4. SEPARATE TIE ROD END SUB-ASSEMBLY
(a) Remove the cotter pin and nut.
(b) Using SST, separate the tie rod end sub-assembly from the steering knuckle. SST: 09628-62011 |
|
5. REMOVE FRONT AXLE HUB NUT
(a) Using a screwdriver and a hammer, remove the front axle hub grease cap.
(b) Remove the cotter pin and adjusting cap. |
|
(c) Remove the front axle hub nut.
6. SEPARATE FRONT SUSPENSION LOWER ARM
(a) Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.
7. REMOVE FRONT DRIVE SHAFT
(a) Using SST, remove the front drive shaft.
SST: 09520-01010
SST: 09520-24010
09520-32040
NOTICE:
Be careful not to damage the oil seal.
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecting the cable from the negative (-) battery terminal notices before pr ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Steering Lock System
DTC Code
Detection Item
See page
B2781
Open / Short in Steering Lock ECU
B2782
Power Source Control ECU Malfunction
...