Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / Differential / Bd22an Differential Carrier Assembly(w/ Differential Lock) / Removal

REMOVAL

CAUTION / NOTICE / HINT

Text in Illustration

*a	Object Exceeding Weight Limit of Transmission Jack

Be sure to perform this procedure with several people as the rear differential carrier assembly is very heavy.
Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.

PROCEDURE

1. REMOVE REAR WHEELS

2. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 2WD)

(See page 3. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 4WD) )

3. REMOVE REAR PROPELLER SHAFT ASSEMBLY (for 4WD)

(See page 4. DRAIN DIFFERENTIAL OIL )

4. DRAIN DIFFERENTIAL OIL

(See page 5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH )

5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE LH

(See page 6. REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH )

6. REMOVE REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described for the LH side.

7. REMOVE REAR DIFFERENTIAL PROTECTOR

(a) Remove the 2 bolts and differential protector from the differential carrier assembly.

8. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

(a) Disconnect the 2 connectors.

(b) Remove the 10 nuts, 10 washers and rear differential carrier assembly.

NOTICE:

Be careful not to damage the contact surface.

CAUTION:

The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

NOTICE:

Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.
The remaining oil may leak out when removing the rear differential carrier assembly.
Do not damage the installation surface when removing the rear differential carrier assembly.
Remove the bolts with the rear differential carrier assembly secured.

9. REMOVE REAR DIFFERENTIAL CARRIER GASKET

Components

COMPONENTS ILLUSTRATION HINT: The following specifications are for BD22AN (w/ Differential Lock). BD22AN differentials are equipped with M10 rear differential carrier to rear axel housing fastene ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: The following procedures are for BD22 (w/ Differential Lock). PROCEDURE 1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY (a) Clean the contact surfaces of ...

Other materials:

Driver Side Power Window does not Operate with Power Window Master Switch
DESCRIPTION When the engine is running or the ignition switch is ON, the front power window regulator motor assembly LH is operated by the power window regulator master switch assembly. The front power window regulator motor assembly LH has motor, regulator, and ECU functions. HINT: If the ...

ABS Warning Light does not Come ON
DESCRIPTION Refer to ABS Warning Light Remains ON (See page ). WIRING DIAGRAM Refer to ABS Warning Light Remains ON (See page ). CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (master cylinder solenoid), perform calibration (See page ). Inspect the ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL-SAFE OPERATION AND DEACTIVATION CONDITION DIFFERENTIAL SYSTEM (w/ Differential Lock) DTC No. Fail-safe Operation Fail-safe Deactivation Condition U0122 All switching prohibited When rear differential is locked ...