REMOVAL
PROCEDURE
1. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
(See page )
2. REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING
(a) Remove the compression spring. |
|
3. REMOVE CLUTCH PEDAL SUB-ASSEMBLY
(a) Remove the bolt and nut. |
|
(b) Remove the clutch pedal sub-assembly from the clutch pedal support.
4. REMOVE CLUTCH PEDAL SPRING HOLDER
(a) Remove the clutch pedal spring holder from the clutch pedal support. |
|
5. REMOVE CLUTCH PEDAL PAD
6. REMOVE CLUTCH PEDAL BUSH
(a) Remove the 2 bushes from the clutch pedal sub-assembly. |
|
7. REMOVE CLUTCH PEDAL SHAFT COLLAR
(a) Remove the clutch pedal shaft collar from the clutch pedal sub-assembly. |
|
8. REMOVE CLUTCH PEDAL NO.1 CUSHION
(a) Using needle-nose pliers, remove the clutch pedal No. 1 cushion from the clutch pedal sub-assembly. |
|
Road Test
ROAD TEST
PROBLEM SYMPTOM CONFIRMATION
HINT:
The dynamic radar cruise control system has 2 cruise control modes:
constant speed control mode and vehicle-to-vehicle distance control mode.
Vehicle-to-vehicle distance control mode is selected by default when
the dyna ...
System Diagram
SYSTEM DIAGRAM
Transmitting ECU (Transmitter)
Receiving ECU
Signal
Communication Method
4 wheel drive control ECU
Skid control ECU (Brake actuator assembly)
Rear differential lock status signal
H ...
Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD
(See page )
2. REMOVE STEERING WHEEL ASSEMBLY
3. REMOVE LOWER STEERING COLUMN COVER
4. REMOVE UPPER STEERING COLUMN COVER
5. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR
(a) Slide the slider and disconnect the airbag connector ...