REMOVAL
PROCEDURE
1. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
2. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(See page )
3. REMOVE NO. 1 OIL COOLER INLET TUBE AND NO. 1 OIL COOLER OUTLET TUBE
NOTICE:
When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.
HINT:
Use a container to catch any ATF.
(a) Disconnect the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube from the automatic transmission assembly. |
|
(b) Slide the 2 clips and disconnect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube. |
|
(c) Remove the bolt and flexible hose clamp from the automatic transmission assembly.
Text in Illustration
*1 |
Flexible Hose Clamp |
*2 |
Oil Cooler Tube Clamp |
(d) Remove the 2 bolts to open the 2 oil cooler tube clamps and remove the No. 1 oil cooler inlet tube and No. 1 oil cooler outlet tube.
(e) Remove the 2 bolts and 2 oil cooler tube clamps from the engine assembly.
4. REMOVE NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE
NOTICE:
When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.
HINT:
Use a container to catch any ATF.
(a) Slide the 2 clips and remove the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose from the oil cooler tube. |
|
5. REMOVE NO. 4 OIL COOLER INLET HOSE AND NO. 4 OIL COOLER OUTLET HOSE
NOTICE:
When disconnecting the hoses from the tube, support the tube by hand and be careful to prevent the tube from being deformed.
HINT:
Use a container to catch any ATF.
(a) Detach the claw to open the clamp. |
|
(b) Slide the 2 clips and disconnect the No. 4 oil cooler inlet hose and No. 4 oil cooler outlet hose from the oil cooler tube.
(c) Slide the 2 clips and remove the No. 4 oil cooler inlet hose and No. 4 oil cooler outlet hose from the radiator assembly.
6. REMOVE OIL COOLER TUBE
(a) Remove the 2 bolts and oil cooler tube from the vehicle body. |
|
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL COMPRESSOR PICK UP SENSOR
(a) Install the compressor pick up sensor with the 3 screws.
(b) Engage the clamp.
2. INSTALL MAGNET CLUTCH ASSEMBLY
(a) Secure the cooler compressor assembly in a vise between ...
Fuel Tank Cap
Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL TANK CAP ASSEMBLY
(a) Check the appearance of the fuel tank cap assembly.
(1) Check that there is no deformation or damage to the fuel tank cap assembly
or fuel tank cap gasket.
*1
Fuel Tank Cap Gasket
If the ...
Transfer Shift Motor Limit Switch Circuit (P17AC)
DESCRIPTION
When the transfer switches modes, the TL1, TL2 and TL3 terminals of the limit
switch are in one of the ON/OFF combinations listed in the table below.
Terminal
When 2WD
Switching between 2WD and H4
When H4
Switching between H4 and ...