Toyota Tacoma (2015-2018) Service Manual: Refrigerant(for Hfo-1234yf(r1234yf))

Replacement

REPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM (a) Start up the engine. (b) Turn the A/C switch to ON. (c) Operate the cooler compressor with an engine speed of approximat ...

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REFRIGERANT PRESSURE (a) This method uses a refrigerant recovery unit set to locate problem areas. Read the refrigerant pressure when the test condition ...

Other materials:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. 2. CLEAR DTC (a) Connect the Techstream to the DLC3. ( ...

Engine Coolant Temperature Sensor
Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR (a) Partially immerse the engine coolant temperature sensor in water and warm up the water. (b) Measure the resistance according to the value(s) in the table bel ...

Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact. PROCEDURE 1. INSTALL BLIND SPOT MONITOR SENSOR LH (a) Install the blind spot monitor sensor LH with the 3 nuts. Torque: 9.0 N·m {92 kgf·cm, 80 in·l ...