REASSEMBLY
PROCEDURE
1. INSTALL FRONT OIL PUMP OIL SEAL
(a) Using SST and a hammer, install a new front oil pump oil seal to the front oil pump body sub-assembly. SST: 09350-30020 09351-32140 Standard depth: -0.3 to 0.3 mm (-0.0118 to 0.0118 in.) |
|
(b) Coat the lip of the front oil pump oil seal with MP grease.
2. SECURE FRONT OIL PUMP BODY SUB-ASSEMBLY
(a) Place the front oil pump body sub-assembly on the torque converter assembly.
3. INSTALL FRONT OIL PUMP DRIVEN GEAR
(a) Coat the front oil pump driven gear with ATF and install it to the front oil pump body sub-assembly. |
|
4. INSTALL FRONT OIL PUMP DRIVE GEAR
(a) Coat the front oil pump drive gear with ATF and install it to the front oil pump body sub-assembly. |
|
5. INSTALL STATOR SHAFT ASSEMBLY
(a) Align the bolt holes of the stator shaft assembly with the bolt holes of the front oil pump body sub-assembly and install the stator shaft assembly to the front oil pump body sub-assembly. |
|
(b) Using a T30 "TORX" socket wrench, install the 7 screws.
Torque:
11 N·m {110 kgf·cm, 8 ft·lbf}
6. INSTALL FRONT OIL PUMP PLATE
(a) Using a T30 "TORX" socket wrench, install the front oil pump plate with the 3 screws. Torque: 11 N·m {110 kgf·cm, 8 ft·lbf} |
|
7. INSPECT OIL PUMP DRIVE GEAR ROTATION
8. INSTALL CLUTCH DRUM OIL SEAL RING
(a) Coat 2 new clutch drum oil seal rings with ATF and install them to the oil pump assembly NOTICE:
|
|
9. INSTALL FRONT OIL PUMP BODY O-RING
(a) Coat a new front oil pump body O-ring with ATF and install it to the oil pump assembly. |
|
ECU Power Source Circuit
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
1.
INSPECT BATTERY
(a) Check the battery voltage.
Standard voltage:
11 to 14 V
NG
...
Initialization
INITIALIZATION
1. RESET MEMORY
NOTICE:
Perform Reset Memory (AT initialization) when replacing the automatic
transmission assembly, transmission valve body assembly or any of the shift
solenoid valves.
Reset Memory can be performed only with the Techstream.
HINT:
The E ...
Lost Communication with Alternator Missing Message (P161A87)
DESCRIPTION
The ECM communicates with the generator assembly via LIN communication. If a
LIN communication error is detected, the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
P161A87
Generator assembly or ECM commu ...