Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Rear Seat Inner Belt Assembly(for Double Cab)

Toyota Tacoma (2015-2018) Service Manual / Seat Belt / Rear Seat Inner Belt Assembly(for Double Cab)

Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR SEAT INNER BELT ASSEMBLY

(a) for LH Side:

(1) Install the rear seat inner belt assembly with the bolt.

Text in Illustration

*a

Protruding Part

*b

40°

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

NOTICE:

  • Make sure that the rear seat inner belt assembly is oriented in the correct direction when installing.
  • Do not allow the anchor part of the rear seat inner belt assembly to overlap the protruding part of the floor panel.

(b) for RH Side:

(1) Connect the rear seat inner belt assembly and rear center seat outer belt assembly by installing the floor anchor with the bolt.

Text in Illustration

*a

Protruding Part

*b

40°

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

NOTICE:

  • Make sure that the rear seat inner belt assembly and rear center seat outer belt assembly is oriented in the correct direction when installing.
  • Do not allow the anchor part of the rear seat inner belt assembly and rear center seat outer belt assembly to overlap the protruding part of the floor panel.

Removal

REMOVAL

PROCEDURE

1. REMOVE REAR SEAT INNER BELT ASSEMBLY

(a) for LH Side:

(1) Remove the bolt and rear seat inner belt assembly.

(b) for RH Side:

(1) Remove the bolt and rear seat inner belt assembly.

Rear Seat Inner Belt Assembly(for Access Cab)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY (a) Open the 2 anchor covers. (b) Loosen the 2 bolts to remove the 2 ...

Rear Seat Outer Belt Assembly(for Access Cab)
...

Other materials:

Front Radar Sensor Region Code Mismatch (C1A0A)
DESCRIPTION The forward recognition camera receives necessary information from the millimeter wave radar sensor assembly. When the forward recognition camera judges that a millimeter wave radar sensor assembly which is not compatible with the vehicle has been installed, DTC C1A0A is stored. ...

Installation
INSTALLATION PROCEDURE 1. INSTALL VANE PUMP ASSEMBLY (a) Install the vane pump assembly with the 2 bolts. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect the ground wire with the bolt. Torque: 8.5 N·m {87 kgf·cm, 75 in·lbf} 2. CONNECT PRESSURE FEED TUBE ASSEMBLY (a) Install a ne ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

© 2011-2024 Copyright www.ttguide.net