DESCRIPTION
The No. 1 ultrasonic sensor (rear center sensor LH) is installed on the rear bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic sensor (rear center sensor LH). If the No. 1 ultrasonic sensor (rear center sensor LH) has an open circuit or other malfunction, it will not function normally.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
C1AE7 |
A malfunction of the No. 1 ultrasonic sensor (rear center sensor LH). |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the ignition switch to ON and turn the back sonar or clearance sonar switch assembly on. Then clear the DTCs (See page ).
PROCEDURE
1. |
CHECK DTC OUTPUT |
(a) Check for DTCs (See page ).
Result
Result |
Proceed to |
---|---|
Only DTC C1AE7 is output |
A |
DTC C1AE7 and C1AED are output |
B |
No DTCs are output |
C |
B |
GO TO DTC (C1AED) |
C |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE NO. 1 ULTRASONIC SENSOR (REAR CENTER SENSOR LH) |
(a) Replace the No. 1 ultrasonic sensor (rear center sensor LH) with a known good one (See page ).
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
3. |
CHECK DTC OUTPUT |
(a) Clear the DTCs (See page ).
(b) Check for DTCs (See page ).
Result
Result |
Proceed to |
---|---|
No DTCs are output |
OK |
DTC C1AE7 is output |
NG |
OK |
END (REAR CENTER SENSOR LH WAS DEFECTIVE) |
NG |
REPLACE CLEARANCE WARNING ECU ASSEMBLY |
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a DTC is displayed during the DTC check, check the parts listed in
the table below and proceed to the "See page" given.
*1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates.
*2: "DTC stored" means ...
Check Bus 2 Lines for Short Circuit
DESCRIPTION
There may be a short circuit between the CAN main bus lines and/or CAN branch
lines when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central
gateway ECU (network gateway ECU) is below 54 Ω.
Detection Item
Trouble Area
Resi ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR NO. 2 POWER WINDOW REGULATOR SWITCH ASSEMBLY
*a
Component without harness connected
(Rear No. 2 Power Window Regulator Switch Assembly)
*b
Pull (Close)
*c
Push (Open)
...