Toyota Tacoma (2015-2018) Service Manual: Rear Console Box

Toyota Tacoma (2015-2018) Service Manual / Interior / Rear Console Box

Components

COMPONENTS

ILLUSTRATION

Installation

INSTALLATION

PROCEDURE

1. INSTALL BOX BOTTOM MAT

(a) Engage the 10 guides and install the 2 box bottom mats.

2. INSTALL CONSOLE BOX PLATE

(a) Engage the 2 guides and install the console box plate.

(b) Install the 6 screws.

3. INSTALL REAR LOWER CONSOLE BOX

(a) Engage the 2 guides and install the lower console box.

(b) Install the 4 bolts.

4. INSTALL FRONT CENTER CONSOLE MAT

(a) Install the front center console mat.

5. INSTALL REAR CENTER CONSOLE MAT

(a) Install the rear center console mat.

6. INSTALL FLOOR BOARD

(a) Return the floor board and engage the lock.

HINT:

Use the same procedure for both sides.

Removal

REMOVAL

PROCEDURE

1. REMOVE FLOOR BOARD

(a) Release the lock and fasten the floor board to the seat bottom.

HINT:

Use the same procedure for both sides.

2. REMOVE REAR CENTER CONSOLE MAT

(a) Remove the front center console mat.

3. REMOVE FRONT CENTER CONSOLE MAT

(a) Remove the rear center console mat.

4. REMOVE REAR LOWER CONSOLE BOX

(a) Remove the 4 bolts.

(b) Disengage the 2 guides and remove the lower console box.

5. REMOVE CONSOLE BOX PLATE

(a) Remove the 6 screws.

(b) Disengage the 2 guides and remove the console box plate.

6. REMOVE BOX BOTTOM MAT

(a) Disengage the 10 guides and remove the 2 box bottom mats.

Front Floor Footrest

Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL FRONT FLOOR FOOTREST (a) Engage the 2 clips to install the front floor footrest. ...

Roof Headlining(for Access Cab)

...

Other materials:

Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION for Audio Function: The radio and display receiver assembly receives a vehicle speed signal from the combination meter assembly and sends the signal to radio and display receiver assembly. for Automatic Sound Levelizer (ASL): This circuit is necessary fo ...

Output Speed Sensor Circuit Short to Battery (P072012,P072014,P072031)
DESCRIPTION This sensor detects the rotation speed of the transmission output shaft and sends signals to the ECM. By comparing the input turbine speed signal (NT) with the output shaft speed sensor signal (SP2), the ECM detects the shift timing of the gears and appropriately controls the engi ...

Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS HINT: Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the Techstream when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default) ...