Toyota Tacoma (2015-2018) Service Manual: Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
DESCRIPTION
DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor assembly.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
|---|---|---|---|---|
|
C1A52 |
Radar Cruise Control Presence Determination Malfunction (Engine / HV) |
Approximately 17 seconds after the ignition switch is turned to ON, the ECM cannot recognize the millimeter wave radar sensor assembly for approximately 1.3 seconds or more. |
|
Does not come on |
CAUTION / NOTICE / HINT
NOTICE:
- When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
- When the millimeter wave radar sensor assembly is replaced with a new
one, adjustment of the radar sensor beam axis must be performed.
Click here
.gif)
- Before replacing the ECM, refer to Registration.
w/o Smart Key System: Click here
w/ Smart Key System: Click here
PROCEDURE
|
1. |
CHECK FOR DTC (RADAR CRUISE 2) |
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Turn the ignition switch to ON.
- Wait for 20 seconds or more.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC C1A52 is not output |
A |
|
DTC C1A52 is output |
B |
| A | .gif) |
USE SIMULATION METHOD TO CHECK |
|
.gif)
|
2. |
REPLACE ECM |
(a) Replace the ECM.
Click here
|
|
3. |
CHECK FOR DTC (RADAR CRUISE 2) |
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the system cannot detect the malfunction.
- Turn the ignition switch to ON.
- Wait for 20 seconds or more.
(c) Check for DTCs.
Click here
|
Result |
Proceed to |
|---|---|
|
DTC C1A52 is not output |
A |
|
DTC C1A52 is output |
B |
| A | |
END (ECM WAS DEFECTIVE) |
| B | |
REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
Skid Control Buzzer Circuit (C1A4A)
DESCRIPTION
Based on dynamic radar cruise control system operation, the forward recognition
camera provides warnings to the driver by sounding the skid control buzzer.
DTC C1A4A is stored when a m ...
Brake Switch "A" Circuit Open (P057113)
DESCRIPTION
When the brakes are applied by the dynamic radar cruise control system, the skid
control ECU (master cylinder solenoid)*1 or skid control ECU (brake actuator assembly)*2
operates the ...
Other materials:
System Description
SYSTEM DESCRIPTION
1. CRUISE CONTROL SYSTEM
The cruise control system makes it possible to drive at a desired speed without
using the accelerator pedal. ECM controls the throttle opening angle based on signals
from switches and sensors.
The microcomputer which controls the cruise control syst ...
Transmitter ID not Registered (C2171/71)
DESCRIPTION
The IDs of each tire pressure warning valve and transmitter are registered to
the tire pressure warning ECU and receiver.
When the ECU detects that a transmitter ID code is not registered in the ECU,
this DTC is stored.
DTC No.
Detection Item
DTC D ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
