Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Ptc Heater Relay

Components

COMPONENTS

ILLUSTRATION

Inspection

Inspection

INSPECTION

PROCEDURE

1. INSPECT PTC HEATER RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

3 - 5

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the ptc heater relay.

Installation

INSTALLATION

PROCEDURE

1. INSTALL PTC HEATER RELAY

(a) Install the ptc heater relay.

Removal

REMOVAL

PROCEDURE

1. REMOVE PTC HEATER RELAY

(a) Remove the ptc heater relay.

Ptc Heater Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (See page ) 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY 3. REMOVE ...

Refrigerant Line
Components COMPONENTS ILLUSTRATION ...

Other materials:

Transfer Oil
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. CHECK TRANSFER OIL (a) Remove the filler plug and gasket. Text in Illustration *1 Filler Plug (b) Check that the ...

Transmitter ID1 Operation Stop (C2111/11-C2114/14)
DESCRIPTION The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measu ...

Terminals Of Ecu
TERMINALS OF ECU 1. MOBILE WIRELESS CHARGER CRADLE ASSEMBLY Tester Connection Wiring Color Terminal Description Condition Specified Condition M5-1 (ACC) - M5-5 (PGND) GR - W-B Power source (ACC) ...

© 2011-2026 Copyright www.ttguide.net