Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Symptom

Suspected Area

See page

When ignition switch in ON position, SRS warning light occasionally comes on approximately 6 seconds after engine start.

SRS warning light circuit malfunction (SRS Warning Light Remains ON).

SRS warning light always comes on even when DTC not set.

SRS warning light circuit malfunction (SRS Warning Light Remains ON).

With ignition switch in ON position, SRS warning light does not come on.

SRS warning light circuit malfunction (SRS Warning Light does not Come On).

Although SRS warning light operates normally, neither DTCs normal system indication displayed.

TC and CG Terminal Circuit

Although terminals TC and CG not connected, DTC or normal system indication displayed.

TC and CG Terminal Circuit

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

System Description
SYSTEM DESCRIPTION 1. SRS (SUPPLEMENTAL RESTRAINT SYSTEM) AIRBAG SYSTEM (a) General Description (1) The SRS airbag system consists of the following airbag and main components: Airbag ...

Other materials:

System Description
SYSTEM DESCRIPTION 1. GENERAL This system has the following functions: manual slide open and close; auto slide open and close; manual tilt up and down; auto tilt up and down; jam protection; key off operation; key-linked open and close; wireless transmitter-linked open sliding roof open warn ...

Pressure Control Solenoid "C" Actuator Stuck Off (P07957F)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...

Vacuum Pump
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL VACUUM PUMP ASSEMBLY (a) Apply engine oil to the 2 O-rings on the vacuum pump assembly. (b) Apply engine oil to the inner surface of the installation hole. (c) Install the vacuum pump assembly so that th ...

В© 2011-2024 Copyright www.ttguide.net