PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
STEERING SYSTEM
Symptom |
Suspected Area |
See page |
---|---|---|
Hard steering |
1. Tires (Improperly inflated) |
|
2. Power steering fluid level (Low) |
|
|
3. Drive belt (Loose) |
|
|
5. Front wheel alignment (Incorrect) |
|
|
6. Steering system joints (Worn) |
- |
|
8. Suspension arm ball joints (Worn) |
|
|
9. Steering column (Binding) |
- |
|
10.Power steering vane pump (for 2TR-FE) |
|
|
11.Power steering vane pump (for 2GR-FKS) |
|
|
12.Power steering gear |
|
|
Poor return |
1. Tires (Improperly inflated) |
|
3. Front wheel alignment (Incorrect) |
|
|
4. Steering column (Binding) |
- |
|
5. Power steering gear |
|
|
Excessive free play |
1. Steering system joints (Worn) |
- |
3. Suspension arm ball joints (Worn) |
|
|
4. Intermediate shaft sliding yoke (Worn) |
- |
|
6. Front wheel bearing (Worn) |
|
|
7. Power steering gear |
|
|
Abnormal noise |
1. Power steering fluid level (Low) |
|
2. Steering system joints (Worn) |
- |
|
3. Power steering vane pump (2TR-FE) |
|
|
4. Power steering vane pump (2GR-FKS) |
|
|
5. Power steering gear |
|
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK AND MAIN BODY ECU (MULTIPLEX NETWORK BODY
ECU)
(a) Disconnect the MB main body ECU (multiplex network body ECU) connectors.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on ...
Data List / Active Test
DATA LIST / ACTIVE TEST
READ DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows ...
Communication Error from VSC to ECM (P1630)
DESCRIPTION
The skid control ECU (brake actuator assembly) sends signals such as cruise control
cancel signals and brake demand response signals to the ECM when the dynamic radar
cruise control system is operating.
DTC No.
Detection Item
DTC Detection Condition ...