PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Symptom |
Suspected Area |
See page |
---|---|---|
Hard steering |
Tires (Improperly inflated) |
|
Power steering fluid level (Low) |
|
|
Drive belt (Loose) (2TR-FE) |
|
|
Drive belt (Loose) (2GR-FKS) |
|
|
Front wheel alignment (Incorrect) |
|
|
Steering system joints (Worn) |
- |
|
Suspension arm ball joints (Worn) |
|
|
Steering column (Binding) |
- |
|
Vane pump (2TR-FE) |
|
|
Vane pump (2GR-FKS) |
|
|
Power steering link (2TR-FE) |
|
|
Power steering link (2GR-FKS) |
|
|
Poor return |
Tires (Improperly inflated) |
|
Front wheel alignment (Incorrect) |
|
|
Steering column (Binding) |
- |
|
Power steering link (2TR-FE) |
|
|
Power steering link (2GR-FKS) |
|
|
Excessive play |
Steering system joints (Worn) |
- |
Suspension arm ball joints (Worn) |
|
|
Intermediate shaft, Sliding yoke (Worn) |
- |
|
Front wheel bearing (Worn) |
|
|
Power steering link (2TR-FE) |
|
|
Power steering link (2GR-FKS) |
|
|
Abnormal noise |
Power steering fluid level (Low) |
|
Steering system joints (Worn) |
- |
|
Vane pump (2TR-FE) |
|
|
Vane pump (2GR-FKS) |
|
|
Power steering link (2TR-FE) |
|
|
Power steering link (2GR-FKS) |
|
Unusual Bank Angle Detected (C1440)
DESCRIPTION
If the skid control ECU (brake actuator assembly) determines that the vehicle
is being driven at a steep bank angle, the skid control ECU (brake actuator assembly)
stores DTC C1440 while VSC operation is temporarily disabled.
This is not a malfunction if the system and sensor circu ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the air conditioning system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE FRONT LOWER ARM BUSH NO. 1
(a) Using a hammer and chisel, raise the flange of the bush diagonally as shown
in the illustration.
(b) Using SST, remove the lower arm bush.
SST: 09950-40011
09951-04010
09952-04010
09953-04020
09954-04010 ...