Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
See page |
|---|---|---|
|
Tire pressure warning light does not illuminate despite tire pressure decreasing |
Initialization |
|
|
Check Data List (ID Tire Inflation Pressure) |
|
|
|
ID code check (Registration) |
|
|
|
Tire pressure warning light remains illuminated (Goes off during initial check) |
Tire pressure warning light circuit |
|
|
Tire pressure warning light remains illuminated (Illuminates during initial check) |
Check Data List (ID Tire Inflation Pressure) |
|
|
Tire pressure adjustment |
|
|
|
ID code check (Registration) |
|
|
|
Initialization |
|
|
|
Initialization cannot be done |
Tire pressure warning reset switch |
|
|
DTC check cannot be done using SST check wire |
TC and CG terminal circuit |
|
|
ECU power source circuit |
|
|
|
Tire position not identified* |
Tire pressure warning valve and transmitter |
|
|
Main body ECU (Multiplex network body ECU) |
- |
.gif)
- *: w/ Tire Inflation Pressure Display Function
Registration
REGISTRATION
PROCEDURE
1. BEFORE REGISTRATION
NOTICE:
The transmitter ID is written on the tire pressure warning valve and transmitter.
It is not possible to read the transmitter ID after instal ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK TIRE PRESSURE WARNING ECU AND RECEIVER
(a) Disconnect the T14 tire pressure warning ECU and receiver connector and measure
the voltage and resistance on the wire harness ...
Other materials:
Turn Signal Switch Circuit
DESCRIPTION
The combination meter assembly receives the turn signal switch information and
controls the turn signal lights.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM (TURN SIGNAL SWITCH)
(a) Connect the Techstream to the DLC3.
(b) Turn the igni ...
Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
DESCRIPTION
DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor
assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1A52
Radar Cruise Control Presence Determination Malfuncti ...
Lost Communication with ECM / PCM "A" (U0100,U0104,U0122,U0125,U0126,U0129)
DESCRIPTION
The millimeter wave radar sensor assembly and ECM communicate with each sensor
and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN
communication system DTCs are stored.
DTC No.
Detection Item
...
