PRECAUTION
1. PRECAUTIONS WHEN USING TECHSTREAM
(a) When using the Techstream to troubleshoot the engine immobiliser system:
Connect the Techstream to the DLC3 while the ignition switch is off, and turn a door courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
2. PRECAUTIONS FOR THE KEY
(a) The key is a precision instrument. Be sure to observe the following:
(1) Do not drop or strike the key.
(2) Do not allow the key to be kept in a high temperature place for a long time.
(3) Do not use an ultrasonic washing machine to clean the key.
(4) Keep the key away from magnets or magnetized items during use.
(5) Do not attach any stickers to the key.
3. PRECAUTION FOR REGISTRATION
(a) If replacing any of the following parts, refer to the registration procedures (See page ).
NOTICE:
Any keys or ECUs for which registration has been performed cannot be reused.
(1) Key
(2) Transponder key ECU assembly
(3) ECM
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal.
Therefore, make sure to read the disconnecting the cable from the negative (-)
battery terminal notices before p ...
Removal
REMOVAL
PROCEDURE
1. REMOVE TIMING CHAIN COVER ASSEMBLY
(See page )
2. SEPARATE NO. 2 WATER BY-PASS PIPE (for Vacuum Brake Booster)
3. REMOVE VACUUM PUMP ASSEMBLY (for Vacuum Brake Booster)
4. SET NO. 1 CYLINDER TO TDC/COMPRESSION
5. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY
6. REMO ...
Starter Relay
Inspection
INSPECTION
PROCEDURE
1. INSPECT STARTER RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Connection
Specified Condition
3 - 5
...