PRECAUTION
1. DOOR CONTROL RECEIVER EXPRESSIONS
(a) The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Vehicle Specification |
Part Name in Manual |
Actual Part Name |
|---|---|---|
|
w/ Tire Pressure Warning |
Door control receiver |
Door control and tire pressure monitoring system receiver assembly |
|
w/o Tire Pressure Warning |
Door control receiver |
Door control receiver |
2. PRECAUTION WHEN USING TECHSTREAM
(a) When using the Techstream to troubleshoot the power door lock control system:
Connect the Techstream to the DLC3 while the ignition switch is off, and turn a door courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.
(b) After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned ON (IG).
Parts LocationSteering Angle Sensor Initialization Incomplete (C1439,C1445)
DESCRIPTION
The skid control ECU (master cylinder solenoid) acquires steering angle sensor
(spiral cable with sensor sub-assembly) zero point every time the ignition switch
is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately
5 seconds. The ECU also stores t ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEATBACK HEATER ASSEMBLY
(a) Check the operation of the front seatback heater assembly.
(1) Apply battery voltage and check the operation of the front seatback
heater assembly.
OK:
Connection
Conditio ...
Ignition Coil And Spark Plug
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repairs" after replacing the spark plug (See page
).
(a) Install the 6 spark plugs.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
2. INSTALL IGNITIO ...