PRECAUTION
1. IGNITION SWITCH EXPRESSION
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle.
The expressions listed in the table below are used in this section.
Expression |
Ignition Switch (Position) |
Engine Switch (Condition) |
---|---|---|
Ignition Switch off |
LOCK |
Off (Lock) |
Ignition Switch ACC |
ACC |
On (ACC) |
Ignition Switch ON |
ON |
On (IG) |
Engine Start |
START |
On (Start) |
2. TROUBLESHOOTING PRECAUTION
(a) When there is a malfunction in the contact point of the terminals or installation problems with parts, removal and installation of the suspected problem parts may return the system to the normal condition either completely or temporarily.
(b) In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as by DTC output and record them before disconnecting each connector or removing and installing parts.
(c) Since the Touch Select 2-4 and High-Low System may be influenced by a malfunction in other systems, be sure to check for DTCs in the other systems.
3. CAN COMMUNICATION SYSTEM PRECAUTION
(a) The CAN communication system is used for data communication between each of the ECUs and sensors. If there is trouble in the CAN communication line, the DTC of the communication line is output.
(b) If the DTC of the CAN communication line is output, repair the malfunction in the communication line and troubleshoot the Touch Select 2-4 and High-Low System.
(c) Since the CAN communication line has its own length and route, it cannot be repaired temporarily with the bypass wire, etc.
4. PRECAUTION FOR WHEN TESTING BRAKES, SPEEDOMETER, ETC.
(a) Make sure that the transfer is in 2WD mode.
Front Camera Module Circuit (C1AA0)
DESCRIPTION
When an internal malfunction is detected in the forward recognition camera, DTC
C1AA0 is stored.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1AA0
Front Camera Module Circuit
3 seconds ...
Engine Immobiliser System Incorrect Assembly (B279C95)
DESCRIPTION
This code is stored when an ECM that is incompatible with the engine immobiliser
system is installed to the vehicle.
DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C95
An ECM ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE TAIL GATE PROTECTOR
(See page )
2. REMOVE TAIL GATE SERVICE HOLE COVER
(a) Using a T30 "TORX" socket wrench, remove the 8 screws and tail gate
service hole cover.
3. REMOVE REAR TELEVISION CAMER ...