DESCRIPTION
The motor relay (semiconductor relay) is built into the hydraulic brake booster and drives the pump motor based on a signal from the skid control ECU (master cylinder solenoid).
DTC No. |
DTC Detecting Condition |
Trouble Areas |
---|---|---|
C1257 |
Open in pump motor input circuit |
Hydraulic brake booster pump motor circuit |
PROCEDURE
1. |
CHECK HYDRAULIC BRAKE BOOSTER PUMP MOTOR OPERATION |
(a) Turn the ignition switch to OFF.
(b) Disconnect the actuator connector (S1).
(c) Depress the brake pedal more than 20 times.
(d) Turn the ignition switch to the ON position.
(e) Check the hydraulic brake booster pump motor operation.
OK:
Hydraulic brake booster pump operates.
NG |
REPLACE MASTER CYLINDER SOLENOID |
|
2. |
RECONFIRM DTC |
(a) Turn the ignition switch to OFF.
(b) Reconnect the actuator connector (S1).
(c) Turn the ignition switch to the ON position.
(d) Clear the DTCs (See page ).
(e) Check if the same DTCs are recorded.
Result |
Proceed to |
---|---|
DTC output |
A |
DTC not output |
B |
A |
REPLACE MASTER CYLINDER SOLENOID |
B |
END |
System Diagram
SYSTEM DIAGRAM
1. OVERALL CAN BUS DIAGRAM
(a) The CAN communication system is composed of 4 buses.
CAN Main Bus Line
Terminating Resistor
CAN Branch Line
*
Gateway Function Equipped ECU
...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a DTC is displayed during the DTC check, check the parts listed in
the table below and proceed to the "See page" given.
*1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates.
*2: "DTC stored" means ...
Cruise Control Input Circuit (P0575)
DESCRIPTION
This DTC is stored when there is a malfunction in the ECM.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P0575
Cruise Control Input Circuit
Either of the following conditions is met:
...