Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL MAP LIGHT BULB
(a) Install the 2 map light bulbs to the 2 map light sockets.
(b) Turn the 2 map light sockets with 2 map light bulbs in the direction indicated by the arrow shown in the illustration to install them |
|
2. INSTALL ROOF CONSOLE BOX ASSEMBLY
(a) Connect the connector.
(b) Engage the 4 clips to install the roof console box assembly.
Removal
REMOVAL
PROCEDURE
1. REMOVE ROOF CONSOLE BOX ASSEMBLY
(a) Using a moulding remover D, disengage the 4 clips to separate the roof console box assembly. |
|
(b) Disconnect the connector to remove the roof console box assembly.
2. REMOVE MAP LIGHT BULB
(a) Turn the 2 map light sockets with the 2 map light bulbs in the direction indicated by the arrow shown in the illustration to remove them. |
|
(b) Remove the map light bulb from the map light socket.
Terminals Of Ecu
TERMINALS OF ECU
1. AIR CONDITIONING AMPLIFIER ASSEMBLY
HINT:
Check from the rear of the connector while it is connected to the air conditioning
amplifier assembly.
Terminal No.
(Symbol)
Wiring Color
Terminal Description
Condition
Spe ...
Engine
General Maintenance
GENERAL MAINTENANCE
CAUTION / NOTICE / HINT
HINT:
Inspect these items when the engine is cold.
PROCEDURE
1. REPLACE CHAIN SUB-ASSEMBLY
HINT:
2TR-FE: See page
2GR-FKS: See page
2. INSPECT DRIVE BELT
HINT:
2TR-FE: See page
2GR-FKS: ...
Slip Indicator Light does not Come ON
DESCRIPTION
Refer to Slip Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform
calibration (See page
).
Inspe ...