Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Side Airbag Sensor(for Access Cab) / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a Diagnostic System Check (See page 2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and ).

2. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)

CAUTION:

For side airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.

(a) Perform a Diagnostic System Check (See page (b) When the center pillar of the vehicle or its periphery is damaged, check ).

(b) When the center pillar of the vehicle or its periphery is damaged, check whether there is any damage to the side airbag sensor. If there are any defects, such as those mentioned below, replace the side airbag sensor with a new one:

Any cracks, dents or chips in the case.
Any cracks or other damage to the connector.
Peeling of the label or damage to the serial number.

3. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision)

CAUTION:

For side airbag sensor removal and installation procedures, see pages and , and carefully follow the correct procedure.

(a) Replace the side airbag sensor.

Components

COMPONENTS ILLUSTRATION ...

Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See ...

Other materials:

Clutch start cancel switch
The switch allows the vehicle to be driven out of difficult situations by cranking the engine with the clutch engaged. Never use the switch for normal engine starting. Be sure to follow the starting procedure. Press the CLUTCH START CANCEL switch to cancel the clutch start system when the ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may ...

VSC OFF Switch Circuit
DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding this switch turns off TRAC and VSC operation. If TRAC and VSC operations are turned off, the TRAC OFF ...