Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page ).

(b) With the curtain shield airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front pillar garnish or roof headlining assembly with a new one:

  • Cuts, minute cracks or marked discoloration on the front pillar garnish or roof headlining assembly around the curtain shield airbag assembly.

2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check (See page ).

(b) With the curtain shield airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the curtain shield airbag assembly with a new one:

  • Cuts, minute cracks or marked discoloration on the curtain shield airbag assembly.
  • Cracks or other damage to the connectors.

CAUTION:

For removal and installation procedures of the curtain shield airbag assembly. Be sure to follow the correct procedure.

Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. PRECAUTION CAUTION: B ...

Other materials:

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT LICENSE PLATE BRACKET (a) Remove the 2 screws and front license plate bracket. 2. REMOVE NO. 4 ENGINE ROOM WIRE (w/ Fog Light) (a) Disconnect the 2 connectors. ...

Pressure Sensor Circuit (B1423)
DESCRIPTION This DTC is stored if refrigerant pressure on the high pressure side is extremely low (176 kPa (1.8 kgf/cm2, 26 psi) or less) or extremely high (3140 kPa (32.0 kgf/cm2, 455 psi) or more). The air conditioner pressure sensor, which is installed on the pipe on the high pressure side ...

Downhill Assist Control system
The downhill assist control system helps to prevent excessive speed on steep downhill descents. ■ System operation The system will operate when the vehicle is traveling under 15 mph (25 km/h) and the front-wheel drive control switch is in the L4 position. Press the DAC switch. The ind ...

В© 2011-2026 Copyright www.ttguide.net