PROCEDURE
1. |
NOISE CONDITION |
(a) Check from which direction the noise comes (front left or right, or rear left or right).
OK:
The location of the noise source can be determined.
NG |
GO TO STEP 3 |
|
2. |
CHECK SPEAKERS |
(a) Check the installation conditions of the speaker units that are located near the noise source and that there are no cracks, scratches, deformation or other failures.
Result
Result |
Proceed to |
---|---|
No malfunction is found |
A |
A speaker is installed incorrectly |
B |
Foreign objects are in the speaker |
C |
A speaker cone paper is broken |
D |
B |
REINSTALL SPEAKER |
C |
REMOVE FOREIGN OBJECT |
D |
REPLACE SPEAKER |
|
3. |
CHECK NOISE CONDITIONS |
(a) Check the noise condition.
HINT:
The radio has a noise prevention function to reduce noise when listening to the radio. If a loud noise occurs, check whether the ground at the antenna mounting base and the noise prevention unit are installed and wired correctly.
Condition under which Noise Occurs |
Noise Source |
---|---|
Noise increases when the accelerator pedal is depressed, but stops when the engine is stopped. |
Generator |
Noise occurs during A/C or heater operation. |
Blower motor |
Noise occurs when the horn switch is pressed and released or when pressed and held. |
Horn |
Noise occurs synchronously with the turn signal blinking pattern. |
Flasher |
Noise occurs during window washer operation. |
Washer |
Noise occurs during wiper operation. |
Wiper |
Noise occurs when the brake pedal is depressed. |
Stop light switch |
Others. |
Static electricity |
HINT:
OK:
The noise source cannot be determined.
OK |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
NG |
REPAIR OR REPLACE NOISE SOURCE |
Disposal
DISPOSAL
CAUTION / NOTICE / HINT
CAUTION:
Before performing pre-disposal deployment of any SRS part, review and closely
follow all applicable environmental and hazardous material regulations. Pre-disposal
deployment may be considered hazardous material treatment.
PROCEDURE
1. PRECAUTION
...
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Powertrain / Radar Cruise 1*1 / Trouble Codes.
(e) Enter the following menus: Powertrain / Radar Cruise 2*2 / Trouble Codes.
(f) C ...
Parking Brake Cable
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER
(See page )
2. REMOVE VOLTAGE INVERTER ASSEMBLY
(See page )
3. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY
(a) Loosen the adjusting n ...