Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL NETWORK GATEWAY ECU
(a) Install the network gateway ECU with the bolt.
Torque:
3.0 N·m {31 kgf·cm, 27 in·lbf}
(b) Connect the connector.
2. INSTALL LOWER INSTRUMENT PANEL ASSEMBLY
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER INSTRUMENT PANEL ASSEMBLY
(See page )
2. REMOVE NETWORK GATEWAY ECU
(a) Disconnect the connector. |
|
(b) Remove the bolt and network gateway ECU.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Charging System
Symptom
Suspected Area
See page
Charging System Warning Displayed
Battery
Generator assembly
Charging system (ON-VEHICLE INSPECTION)
...
Cruise Control Switch Circuit
DESCRIPTION
This circuit sends signals to the ECM depending on the cruise control main switch
condition.
The battery supplies the positive (+) battery voltage to the cruise control main
switch. Then terminal CCS of the ECM receives the voltage as the signal according
to the switch condition. ...
ABS Warning Light Remains ON
DESCRIPTION
If any of the following is detected, the ABS warning light remains on.
The skid control ECU (master cylinder solenoid) connectors are disconnected
from the skid control ECU (master cylinder solenoid).
There is a malfunction in the skid control ECU (master cylinder soleno ...