Toyota Tacoma (2015-2018) Service Manual: Manual Transmission Oil

Toyota Tacoma (2015-2018) Service Manual / Rc62f Manual Transmission / Transaxle / Manual Transmission Oil

Components

COMPONENTS

ILLUSTRATION

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT MANUAL TRANSMISSION OIL

(a) Park the vehicle on a level surface.

(b) Remove the transmission filler plug and gasket.

Text in Illustration

*a	0 to 5.0 mm (0 to 0.196 in.)

If the result is not as specified, add transmission oil.

Manual transmission oil:

Oil grade	Oil viscosity	Standard capacity
Gear oil API GL-3 (GL-4)	SAE 75W-90	2.5 liters (2.6 US qts, 2.2 Imp. qts)

NOTICE:

Too much or too little oil will lead to transmission problems.
After adjusting the oil level, drive the vehicle and check the oil level again.

(d) Inspect for oil leaks when the oil level is low.

(e) Install a new gasket and the transmission filler plug.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

Replacement

REPLACEMENT

PROCEDURE

1. DRAIN MANUAL TRANSMISSION OIL

(a) Remove the manual transmission filler plug and gasket.

(b) Remove the drain plug sub-assembly and gasket and then drain the manual transmission oil.

Torque:

37 N·m {377 kgf·cm, 27 ft·lbf}

2. ADD MANUAL TRANSMISSION OIL

(a) Add manual transmission oil until the oil level is within 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the manual transmission filler plug opening.

Text in Illustration

*a	0 to 5.0 mm (0 to 0.196 in.)

Manual transmission oil:

Oil grade	Oil viscosity	Standard capacity
Gear oil API GL-3 (GL-4)	SAE 75W-90	2.5 liters (2.6 US qts, 2.2 Imp. qts)

3. INSPECT MANUAL TRANSMISSION OIL

Manual Transmission System

Removal

REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make ...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See page ) 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG (See page ) 3. ...

Removal
REMOVAL PROCEDURE 1. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (a) Place matchmarks on the propeller shaft flange and differential flange. Text in Illustration *a Matchmark ...

Connecting Bluetooth®
The following can be performed using Bluetooth® wireless communication: ■ A portable audio player can be operated and listened to via multimedia system ■ Hands-free phone calls can be made via a cellular phone In order to use wireless communication, register and connect a Bluetooth� ...