Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT INTAKE AIR CONTROL VALVE ACTUATOR
(a) Check the operate.
(1) Apply battery voltage to the connector, and check the operation of the intake air control valve actuator gear. Text in Illustration
OK:
NOTICE: Apply battery voltage for 10 seconds or less each time the inspection is performed. If the result is not as specified, replace the intake air control valve actuator. |
|
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INTAKE AIR CONTROL VALVE ACTUATOR
(a) Remove the intake air control valve actuator.
(See page )
(b) Connect the connector to the intake air control valve actuator.
(c) Connect the Techstream to the DLC3.
(d) Turn the ignition switch ON and turn the Techstream on.
(e) Enter the following menus: Powertrain / Engine / Active Test / Control the ACIS VSV Motor Duty Ratio.
(f) Rotate the intake air control valve actuator gear clockwise and check that it turns freely. If the operation is not as specified, replace the intake air control valve actuator. |
|
(g) Disconnect the connector from the intake air control valve actuator.
(h) Install the intake air control valve actuator.
(See page )
Removal
REMOVAL
PROCEDURE
1. REMOVE INTAKE AIR CONTROL VALVE ACTUATOR
(a) Disengage the clamp to separate the heater hose from the intake air surge tank assembly. |
|
(b) Disconnect the connector from the intake air control valve actuator.
(c) Remove the 3 bolts and intake air control valve actuator from the intake air surge tank assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR
(a) Install the intake air control valve actuator to the intake air surge tank assembly with the 3 bolts.
Torque:
6.0 N·m {61 kgf·cm, 53 in·lbf}
(b) Connect the connector to the intake air control valve actuator.
(c) Engage the clamp to install the heater hose to the intake air surge tank assembly.
Rear Right Sensor Malfunction (C1AE9)
DESCRIPTION
The No. 1 ultrasonic sensor (rear corner sensor RH) is installed on the rear
bumper. The ECU detects obstacles based on signals received from the No. 1 ultrasonic
sensor (rear corner sensor RH). If the No. 1 ultrasonic sensor (rear corner sensor
RH) has an open circuit or other ma ...
Components
COMPONENTS
ILLUSTRATION
*A
w/o Navigation System
*B
w/ Navigation System
*C
for Double Cab
*D
for Acces Cab
*E
for 4WD
-
-
*1
...
Cautions & Notices
CAUTION
This is a warning against anything which may cause injury to people if the
warning is ignored. You are informed about what you must or must not do in order
to reduce the risk of injury to yourself and others.
NOTICE
This is a warning against anything which may cause damage to the vehi ...