Toyota Tacoma (2015-2018) Service Manual: Installation

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Emission Control / Canister / Installation

INSTALLATION

PROCEDURE

1. INSTALL CHARCOAL CANISTER LEAK DETECTION PUMP SUB-ASSEMBLY

(a) Engage the 2 claws to install a new charcoal canister leak detection pump sub-assembly to the charcoal canister assembly.

NOTICE:

Do not allow foreign matter such as grease, oil or water to adhere to the O-rings.
Ensure that the claws are engaged properly.

2. CONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY

(a) Align the fuel tank vent hose sub-assembly connector with the charcoal canister assembly, then push in the fuel tank vent hose until the retainer makes a "click" sound to connect the fuel tank vent hose sub-assembly.

NOTICE:

Check that there are no scratches or foreign objects on the disconnected parts of the fuel tank vent hose sub-assembly and charcoal canister assembly before performing the work.
After connecting the fuel tank vent hose sub-assembly, check that the fuel tank vent hose sub-assembly is securely connected by pulling the quick connector.

3. INSTALL CHARCOAL CANISTER ASSEMBLY

(a) Install the charcoal canister assembly with the bolt and 3 nuts.

Torque:

20 N·m {204 kgf·cm, 15 ft·lbf}

(b) Engage the guide to install the wire harness bracket.

Torque:

12.5 N·m {127 kgf·cm, 9 ft·lbf}

(d) Engage the clamp to install the wire harness.

(e) Connect the 3 connectors.

4. CONNECT FUEL TANK VENT HOSE

(a) Align the fuel tank vent hose connector with the charcoal canister assembly, then push in the fuel tank vent hose until the retainer makes a "click" sound to connect the fuel tank vent hose to the charcoal canister assembly.

NOTICE:

Check that there are no scratches or foreign objects on the disconnected parts of the fuel tank vent hose and charcoal canister assembly before performing the work.
After connecting the fuel tank vent hose, check that the fuel tank vent hose is securely connected by pulling the quick connector.

5. CONNECT CHARCOAL CANISTER FUEL HOSE

(a) Connect the charcoal canister fuel hose with hose clip.

6. INSTALL FUEL TANK ASSEMBLY

Click here 7. INSPECT FOR FUEL LEAK

7. INSPECT FOR FUEL LEAK

Click here Emission Control System

Inspection

INSPECTION PROCEDURE 1. INSPECT CHARCOAL CANISTER ASSEMBLY (a) Visually check the charcoal canister assembly. (1) Visually check the charcoal canister assembly for cracks or damage. ...

Emission Control System

...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT CUSHION ASSEMBLY (a) Remove the 2 bolts and rear seat cushion assembly. 2. REMOVE REAR SEATBACK HINGE COVER (a) Disengage the 6 claws to remove the 2 rear seatback hinge covers. ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) The transponder key ECU assembly controls the engine immobiliser system. The engine immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). 2. CHECK DLC3 (a) Check the DLC3 (See page ). 3. ...

System Diagram
SYSTEM DIAGRAM Transmitting ECU (Transmitter) Receiving ECU Signal Communication Method Skid control ECU (Brake actuator assembly) Steering angle sensor (Spiral cable with sensor sub-assembly) Steering angl ...