Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY RH
(a) Connect the connector.
(b) Install the front No. 2 speaker assembly RH with the 2 bolts.
Torque:
8.4 N·m {86 kgf·cm, 74 in·lbf}
NOTICE:
- Do not touch the cone part of the front No. 2 speaker assembly RH.
- When installing the front No. 2 speaker assembly RH to the instrument panel, be careful so that the wires do not get caught between the parts.
2. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY LH
(a) Connect the connector.
(b) Install the front No. 2 speaker assembly LH with the 2 bolts.
Torque:
8.4 N·m {86 kgf·cm, 74 in·lbf}
NOTICE:
- Do not touch the cone part of the front No. 2 speaker assembly LH.
- When installing the front No. 2 speaker assembly LH to the instrument panel, be careful so that the wires do not get caught between the parts.
3. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
(See page .gif)
)
4. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
(See page )
5. INSTALL FRONT PILLAR GARNISH RH
(See page )
6. INSTALL ASSIST GRIP SUB-ASSEMBLY
(See page )
7. INSTALL FRONT PILLAR GARNISH LH
(See page )
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY
(a) When there is a malfunction such as noise from a speaker or no sound at all,
replace the speaker with a new one and check that the ...
Microphone Amplifier
Components
COMPONENTS
ILLUSTRATION
*A
w/o Sliding Roof
*B
w/ Sliding Roof
*1
TELEPHONE MICROPHONE ASSEMBLY
-
...
Other materials:
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY (w/o Amplifier Box Speaker Assembly)
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection
Condition
Specified Condition
1 ...
Parking brake
Lever type
● Sets the parking brake
Fully set the parking brake while depressing the brake pedal.
At this time, the indicator will come on.
● Release the parking brake
Press the button
Turn the lever clockwise
Press it in completely
Pedal type
Sets the parking brake*.
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.
(e) Check for DTCs.
2. DTC CLEAR USING TECHSTREAM
(a) Conn ...
