Toyota Tacoma 2015-2018 Service Manual: Installation

Toyota Tacoma 2015-2018 Service Manual / Lighting / Fog Light Assembly(for Halogen Fog Light) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.

PROCEDURE

1. INSTALL FOG LIGHT ASSEMBLY

(a) Engage the 2 guides to install the fog light assembly.

(b) Install the screw.

2. INSTALL FRONT FENDER LINER

(a) Install the front fender liner with the 2 screws.

3. INSTALL NO. 1 FRONT WHEEL OPENING EXTENSION PAD (w/ Front Spoiler)

4. ADJUST FOG LIGHT AIMING

(See page Fog Light Assembly(for Led Fog Light) )

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FOG LIGHT BU ...

Fog Light Assembly(for Led Fog Light)

...

Other materials:

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR AXLE SHAFT (a) Using a dial indicator, measure the runout of the shaft and flange. Maximum runout: Shaft runout: 1.5 mm (0.0591 in.) Flange runout: 0.05 mm (0.0020 in.) If the rear axle shaft or flange is damaged or worn, or the runout is greater than ...

Front Occupant Classification Sensor RH Collision Detection (B1786)
DESCRIPTION DTC B1786 is set when the occupant detection ECU receives a collision detection signal, which is sent by the front occupant classification sensor RH when an accident occurs. DTC B1786 is also set when the front seat with adjuster frame assembly RH is subjected to a strong impact, ...

Fuel Pump Ecu
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery ...