Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL REAR BUMPER ASSEMBLY

(a) Using an engine lifter or equivalent, engage the 2 pins to install the rear bumper assembly as shown in the illustration.

Text in Illustration

*a

Pin

-

-

NOTICE:

  • Using plate lift attachments or equivalent, set the rear bumper assembly on a flat surface.
  • Be sure to perform the operation with 2 persons or more.
  • Be careful not to damage the rear bumper assembly.

(b) Install the 6 bolts.

Torque:

90 N·m {918 kgf·cm, 66 ft·lbf}

(c) Connect the 3 connectors.

2. INSTALL NO. 1 RECEIVER HITCH ATTACHMENT REINFORCEMENT

(a) Engage the 4 guides and install the 2 No. 1 receiver hitch attachment reinforcements with the 8 bolts.

Torque:

90 N·m {918 kgf·cm, 66 ft·lbf}

3. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION (w/ Blind Spot Monitor)

Click here 4. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Blind Spot Monitor)

4. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Blind Spot Monitor)

Click here Rear Bumper(w/o Towing Package)

Reassembly
REASSEMBLY PROCEDURE 1. INSTALL REAR BUMPER SIDE STAY LH (a) Install the rear bumper side stay LH with the 2 bolts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf} ...

Rear Bumper(w/o Towing Package)
...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT REFRIGERANT PRESSURE (a) This method uses a refrigerant recovery unit set to locate problem areas. Read the refrigerant pressure when the test conditions are established. Test conditions: Temperature at the air inlet with the air recirculation ...

Removal
REMOVAL PROCEDURE 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. REMOVE FRONT WHEELS 3. REMOVE FRONT UPPER FENDER APRON SEAL Click here 4. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package) 5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 6. REMOVE FRONT DIFFERENTIAL CARRI ...

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING (a) Check the spider bearings for wear and damage. (b) Check each spider bearing's axial play by turning the yoke while holding the shaft tightly. Maximum bearing axial play: 0 to 0.05 mm (0 to 0.002 i ...

© 2011-2024 Copyright www.ttguide.net