INSTALLATION
PROCEDURE
1. INSTALL MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
NOTICE:
(a) Set the main body ECU (multiplex network body ECU) to the position where the 2 guides of the main body ECU (multiplex network body ECU) contacts the housing sidewall of the driver side junction block as shown in the illustration. Text in Illustration
HINT: Make sure to keep the angle at 20° or more as shown in the illustration. |
|
(b) While keeping the main body ECU (multiplex network body ECU) in contact with driver side junction block (axis of rotation), lower it as shown in the illustration. |
|
(c) Press the push area until the claw engages to install the main body ECU (multiplex network body ECU). Text in Illustration
NOTICE:
HINT: If a click sound cannot be heard, visually check the engagement of the lock. The engagement can also be confirmed if the main body ECU (multiplex network body ECU) and driver side junction block are flush. |
|
2. INSTALL DRIVER SIDE JUNCTION BLOCK
(a) Connect the 2 connectors on the back side.
(b) Install the driver side junction block with the 2 nuts.
(c) Connect the 5 connectors on the front side.
3. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY
(See page )
Installation
INSTALLATION
PROCEDURE
1. SET NO. 1 CYLINDER TO TDC/COMPRESSION
2. INSTALL CAMSHAFT TIMING GEAR BOLT
NOTICE:
There are different types of camshaft timing gearbolts. Make sure to check the
identification mark todetermine the tightening torque.
*a
Identification Mark ...
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) Sliding roof system data and Diagnostic Trouble Codes (DTCs) can be read
through the vehicle Data Link Connector 3 (DLC3). When the system seems to be malfunctioning,
use the Techstream to check for malfunctions and perform repairs.
2. CHECK DLC3
(a) Check ...
Air Conditioning Compressor Magnetic Clutch Circuit
DESCRIPTION
When the air conditioning amplifier assembly is turned on, a magnetic clutch
on signal is sent from the MGC terminal of the air conditioning amplifier assembly.
Then, the MG CLT relay turns on to operate the magnetic clutch assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NO ...