INSTALLATION
PROCEDURE
1. INSTALL FRONT DRIVE SHAFT
(a) Coat the spline of the inboard joint shaft with gear oil.
(b) Align the shaft splines and install the front drive shaft with a brass bar and hammer.
NOTICE:
HINT:
Whether the inboard joint shaft is in contact with the pinion shaft or not can be confirmed from the sound or feeling when driving it.
2. INSTALL FRONT SUSPENSION LOWER ARM
(a) Install the front lower ball joint attachment with the 2 bolts.
Torque:
160 N·m {1631 kgf·cm, 118 ft·lbf}
3. INSTALL FRONT AXLE HUB NUT
(a) Install the front axle hub nut.
Torque:
235 N·m {2396 kgf·cm, 173 ft·lbf}
(b) Install the adjusting cap and a new cotter pin.
(c) Install the front axle hub grease cap.
4. INSTALL TIE ROD END SUB-ASSEMBLY
(a) Install the tie rod end sub-assembly to the steering knuckle.
(b) Install the nut.
Torque:
91 N·m {928 kgf·cm, 67 ft·lbf}
(c) Install a new cotter pin.
5. INSTALL FRONT SPEED SENSOR
(a) Install the speed sensor wire harness to the steering knuckle with the bolt.
Torque:
13 N·m {133 kgf·cm, 10 ft·lbf}
(b) Engage the 2 clamps.
(c) Install the front speed sensor with the bolt.
Torque:
8.3 N·m {85 kgf·cm, 73 in·lbf}
6. INSTALL FRONT WHEEL
Torque:
113 N·m {1152 kgf·cm, 83 ft·lbf}
7. ADD DIFFERENTIAL OIL
8. INSPECT DIFFERENTIAL OIL
9. INSPECT SPEED SENSOR SIGNAL (for Hydraulic Brake Booster)
(See page )
10. INSPECT SPEED SENSOR SIGNAL (for Vacuum Brake Booster)
(See page )
11. INSPECT FOR DIFFERENTIAL OIL LEAK
12. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(See page )
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER STEERING LINK
(a) Insert the power steering link into the vehicle in the order shown in the
illustration.
Install in this Direction (1)
Install in this Direction (2)
(b) Using SST, inst ...