Toyota Tacoma (2015-2018) Service Manual: Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one.
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
|
(a) for Type A: (1) Engage the 2 guides. (2) Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw. (3) Tighten the 2 bolts and screw in the order shown in the illustration. Torque: Bolt : 2.5 N·m {25 kgf·cm, 22 in·lbf} |
|
|
(b) for Type B: (1) Engage the 2 guides. (2) Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw. (3) Tighten the 2 bolts and screw in the order shown in the illustration. Torque: Bolt : 2.5 N·m {25 kgf·cm, 22 in·lbf} |
|
|
(c) for Type C: (1) Engage the 2 guides. (2) Temporarily install the millimeter wave radar sensor assembly with the 2 bolts and screw. (3) Tighten the 2 bolts and screw in the order shown in the illustration. Torque: Bolt : 2.5 N·m {25 kgf·cm, 22 in·lbf} |
|
2. INSTALL MILLIMETER WAVE RADAR WIRE
|
(a) for Type A: (1) Connect the connector A. (2) Engage the 4 clamps to install the millimeter wave radar wire in the order shown in the illustration. (3) Connect the connector B. |
|
|
(b) for Type B: (1) Connect the connector A. (2) Engage the 4 clamps to install the millimeter wave radar wire in the order shown in the illustration. (3) Connect the connector B. |
|
|
(c) for Type C: (1) Connect the connector A. (2) Engage the 5 clamps to install the millimeter wave radar wire in the order shown in the illustration. (3) Connect the connector B. |
|
3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) When the millimeter wave radar sensor assembly is replaced, adjust the millimeter wave radar sensor assembly.
Click here .gif)
Removal
REMOVAL
PROCEDURE
1. REMOVE MILLIMETER WAVE RADAR WIRE
(a) for Type A:
(1) Disconnect the 2 connectors.
(2) Using a clip remover, disengage the 4 clamps to remove the millimeter
...
Differential
...
Other materials:
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Centering bolts are used to mount the hood hinge and hood lock assembly.
The hood and hood lock assembly cannot be adjusted with the centering bolts
installed. Substitute the centering bolts with standard bolts when making
adjustments ...
Neutral Position Switch Circuit
DESCRIPTION
The ECM uses the neutral position switch installed to the manual transmission
assembly to detect when the transmission is in the neutral position.
WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING TECHSTREAM (NEUTRAL SWITCH)
(a) Connect the Techstream ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the smart key system (for Start
Function).
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...
