INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION WIRE
(a) Coat 2 new O-rings with ATF, and install them to the 2 temperature sensors.
(b) Coat a new O-ring with ATF, and install it to the transmission wire.
(c) Install the transmission wire to the automatic transmission case sub-assembly with the bolt.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
(d) Connect the transmission wire connector.
HINT:
Push up the lever until the claw of the transmission wire connector makes a connection sound.
2. INSTALL TRANSMISSION INSULATOR RH (for 2GR-FKS)
(a) Install the transmission insulator RH to the automatic transmission assembly with the 2 bolts.
Torque:
14 N·m {143 kgf·cm, 10 ft·lbf}
(b) Install the wire harness clamp bracket to the transmission insulator RH with the bolt.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
3. INSTALL TRANSMISSION INSULATOR RH (for 2TR-FE)
(a) Install the transmission insulator RH to the automatic transmission assembly with the 3 bolts.
Torque:
14 N·m {143 kgf·cm, 10 ft·lbf}
4. CONNECT TRANSMISSION WIRE
(a) Connect the 7 solenoid valve connectors. Text in Illustration
|
|
(b) Install the 2 temperature sensors and 2 temperature sensor clamps to the transmission valve body assembly with the bolt.
Torque:
for Bolt A :
10 N·m {102 kgf·cm, 7 ft·lbf}
for Bolt B :
11 N·m {112 kgf·cm, 8 ft·lbf}
5. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
(a) Install the 4 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration. |
|
(b) Install a new automatic transmission oil pan gasket to the automatic transmission oil pan sub-assembly.
(c) Install the automatic transmission oil pan sub-assembly with automatic transmission oil pan gasket to the automatic transmission case sub-assembly with the 10 bolts. Text in Illustration
Torque: 7.4 N·m {75 kgf·cm, 65 in·lbf} NOTICE:
|
|
6. ADD AUTOMATIC TRANSMISSION FLUID
(See page )
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK
(a) Connect the Techstream to the DLC3.
(1) Turn the ignition switch to ON.
NOTICE:
Do not start the engine.
(2) Turn the Techstream on.
(3) Enter the following menus: Powertrain / Engine / Active Test / C ...
PTC Heater Circuit
DESCRIPTION
PTC HTR heater relays are closed in accordance with signals from the air conditioning
amplifier assembly and power is supplied to the quick heater assembly installed
on the radiator heater unit.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits rela ...
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...