INSTALLATION
PROCEDURE
1. INSTALL PARK/NEUTRAL POSITION SWITCH
HINT:
Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.
(a) Clean the bolt and bolt hole.
(b) Apply adhesive to 2 or 3 threads on the end of the bolt.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
(c) Temporarily install the park/neutral position switch to the automatic transmission assembly with the bolt.
HINT:
Tighten the bolt to the specified torque when adjusting the park/neutral position switch.
(d) Install a new lock washer and nut to the park/neutral position switch.
Torque:
6.9 N·m {70 kgf·cm, 61 in·lbf}
(e) Move the shift lever to N.
(f) Align the neutral basic line with the groove as shown in the illustration, and tighten the bolt. Text in Illustration
Torque: 13 N·m {130 kgf·cm, 9 ft·lbf} |
|
(g) Using a screwdriver, bend the tabs of the lock washer.
NOTICE:
HINT:
Tape the screwdriver tip before use.
(h) Connect the park/neutral position switch connector.
2. INSTALL WATER BY-PASS PIPE (for 2GR-FKS)
(a) Install the water by-pass pipe to the automatic transmission assembly with the 2 bolts.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
3. INSTALL TRANSMISSION INSULATOR RH (for 2GR-FKS)
4. INSTALL TRANSMISSION INSULATOR RH (for 2TR-FE)
5. INSPECT PARK/NEUTRAL POSITION SWITCH
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals ...
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Automatic Transmission
-
-
*1
FRONT SPEED SENSOR LH
*2
FRONT SPEED SENSOR RH
*3
FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY LH
- FRONT SP ...
Pressure Control Solenoid "D" Electrical (Shift Solenoid Valve SLT) (P2716)
DESCRIPTION
Refer to the system description for DTC P2714 (See page
).
DTC No.
DTC Detection Condition
Trouble Area
P2716
Open or short is detected in shift solenoid valve SLT circuit for 1 second
or more while driving (1 trip dete ...