INSPECTION
PROCEDURE
1. INSPECT REAR NO. 2 POWER WINDOW REGULATOR SWITCH ASSEMBLY
*a |
Component without harness connected (Rear No. 2 Power Window Regulator Switch Assembly) |
*b |
Pull (Close) |
*c |
Push (Open) |
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
|
---|---|---|---|
6 (UP) - 2 (E) |
Pull (Close) |
Pulled |
Below 1 Ω |
Not pulled |
10 kΩ or higher |
||
4 (DOWN) - 2 (E) |
Push (Open) |
Pushed |
Below 1 Ω |
Not pushed |
10 kΩ or higher |
If the result is not as specified, replace the rear No. 2 power window regulator switch assembly.
(b) Check that the LED illuminates.
(1) Apply battery voltage to the rear No. 2 power window regulator switch assembly.
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → 8 (ILL+) Battery negative (-) → 1 (ILL-) |
LED illuminates |
If the result is not as specified, replace the rear No. 2 power window regulator switch assembly.
Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the lane departure alert system is not functioning properly, the driver
is warned by the lane departure alert indicator and multi-information display warning
message on the combinat ...
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.
(e) Check for details of the DTCs.
Click here
CLEAR DTC
(a) Connect the Te ...
Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION
This DTC is stored when there is an open or short circuit in the communication
line between the rear sensors and the ECU, or when there is a malfunction in a rear
sensor.
DTC No.
DTC Detection Condition
Trouble Area
C1AED
...