Toyota Tacoma (2015-2018) Service Manual: Inspection

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Spiral Cable / Inspection

INSPECTION

PROCEDURE

1. REMOVE SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR

(a) If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:

Scratches, cracks, dents or chips on the connector or the spiral cable sub-assembly.

(b) Inspect the spiral cable sub-assembly.

(1) Set the spiral cable in the center, and measure the resistance in each position where the spiral cable is turned 2.5 times clockwise and counterclockwise.

(2) Turn the spiral cable 2.5 times clockwise from its original position and measure the resistance while turning it 5 times counterclockwise.

Text in Illustration

*a	Connector A (Orange)
*b	Connector B (Black)
*c	Connector C
*d	Connector D
*e	Connector E
*f	Connector F

Standard resistance:

Tester Connection	Condition	Specified Condition
A1 - E2	Always	Below 1 Ω
A2 - E1
B1 - E3
B2 - E4
C1 - F9
C2 - F10
C3 - F11
C4 - F12
C5 - F13
C6 - F14
C7 - F2
C8 - F3
C9 - F4
C10 - F5
C11 - F6
C12 - F7
D1 - F8
D2 - F9
D3 - F1
D4 - F2

NOTICE:

As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.

Removal

REMOVAL PROCEDURE 1. REMOVE STEERING PAD (See page ) 2. REMOVE STEERING WHEEL ASSEMBLY 3. REMOVE LOWER STEERING COLUMN COVER 4. REMOVE UPPER STEERING COLUMN COVER 5. REMOVE SPIR ...

Installation

INSTALLATION PROCEDURE 1. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH SENSOR (a) Check that the ignition switch is OFF. (b) Check that the batt ...

Other materials:

Initialization
INITIALIZATION NOTICE: Initialization can only be performed for vehicles with a tire pressure warning reset switch. If initialization is performed, the existing tire positions will be cleared, but will be automatically identified when the vehicle is driven at 37 km/h (23 mp ...

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system. *: Use the Techstream. PROCEDURE ...

Sliding Roof does not Move by Operating Sliding Roof Control Switch
DESCRIPTION The sliding roof ECU (sliding roof drive gear sub-assembly) receives slide and tilt signals when the sliding roof switch is operated and drives its built-in motor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before ...