Toyota Tacoma (2015-2018) Service Manual: Inspection
INSPECTION
PROCEDURE
1. INSPECT TIE ROD END SUB-ASSEMBLY
.png)
(a) Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the 5th turn.
Torque:
0.49-3.43 N·m {5.0-35.0 kgf·cm, 4.34-30.36 in·lbf}
2. INSPECT POWER STEERING RACK
.png)
(a) Using a dial indicator, check the power steering rack for runout, teeth wear and damage.
Maximum runout:
0.3 mm (0.012 in.)
If necessary, replace the power steering link assembly.
(b) Check the back surface for wear and damage.
If necessary, replace the power steering link assembly.
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE STEERING GEAR OUTLET RETURN TUBE
(a) Using a union nut wrench, remove the steering gear outlet return tube.
2. REMOVE STEERING TURN PRESSURE TUBE
(a) Using a u ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER STEERING LINK
(a) Insert the power steering link into the vehicle in the order shown in the
illustration.
Install in this Direction ...
Other materials:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Noise Occurs from V-ribbed Belt or Generator Assembly
PROCEDURE
1.
CONFIRM PROBLEM SYMPTOM
(a) Confirm the problem symptom.
Result
Result
Proceed to
Noise occurs from fan and generator V belt
A
Noise occurs from generator assembly
B
...
Theft Deterrent System Presence Detection (B279C,B279C95)
DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed,
the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C*1
An ECM that is incom ...
